New Feature
- Support the Insteon Hub (2242-222) as the primary controller instead of a typical PLM. You need to configure the Port on the Config page with the ip address, a colon and the port. ie. 192.168.1.100:8080. This is the same port information you would use to access the Hub's web page.
- Test communications on multiple devices at once. This will ping each device 4 times and present a summary table at the end.
- A Cancel button on the Test Communications features.
Changes
- The plugin interface port is not on the Config page, not on the HS Setup/Interface page. Your current port will be transferred.
- Added Repeat button to Test Communications report pages (1.8.2.3)
- Additional logging for Port Recovery routine (1.8.2.10)
Fixes
- IO Linc in mode 3
- Other misc bugs in 1.7.3.1
- Edit Device Location (1.8.2.3)
- Hub reset and reprogram (1.8.2.3)
- Start error associated with ProcessInsteonTrigger (1.8.2.8)
- Syncing KPL devices when using radio button groups (1.8.2.8)
- 6 key vs 8 key issue generated in 1.8.2.8 (1.8.2.9)
- Threadpool error when using Insteon Hub (1.8.2.10)
New Device Support
- New Dual-band KPL on/off (022C)
- DIN Rail devices
- Water Leak Sensor
To Install:
1. Backup your current hs database and insteon.ini
2. Shutdown HS
3. Copy the hspi_insteon.dll to the homeseer folder
4. For new users only: copy the insteon.lf to the homeseer\config (this will provide a 30-day trial license)
5. Restart HS
- Support the Insteon Hub (2242-222) as the primary controller instead of a typical PLM. You need to configure the Port on the Config page with the ip address, a colon and the port. ie. 192.168.1.100:8080. This is the same port information you would use to access the Hub's web page.
- Test communications on multiple devices at once. This will ping each device 4 times and present a summary table at the end.
- A Cancel button on the Test Communications features.
Changes
- The plugin interface port is not on the Config page, not on the HS Setup/Interface page. Your current port will be transferred.
- Added Repeat button to Test Communications report pages (1.8.2.3)
- Additional logging for Port Recovery routine (1.8.2.10)
Fixes
- IO Linc in mode 3
- Other misc bugs in 1.7.3.1
- Edit Device Location (1.8.2.3)
- Hub reset and reprogram (1.8.2.3)
- Start error associated with ProcessInsteonTrigger (1.8.2.8)
- Syncing KPL devices when using radio button groups (1.8.2.8)
- 6 key vs 8 key issue generated in 1.8.2.8 (1.8.2.9)
- Threadpool error when using Insteon Hub (1.8.2.10)
New Device Support
- New Dual-band KPL on/off (022C)
- DIN Rail devices
- Water Leak Sensor
To Install:
1. Backup your current hs database and insteon.ini
2. Shutdown HS
3. Copy the hspi_insteon.dll to the homeseer folder
4. For new users only: copy the insteon.lf to the homeseer\config (this will provide a 30-day trial license)
5. Restart HS
Comment