I don't know if this is ZWave related or not but as the problem manifests itself immediately after I've issued a HS on command to a ZWave device I'll start here. 
My HS (v1.7.44) completely crashes whilst waiting for the on command to complete. Most ZWave commands are successful instantly but I notice occaisonally some take ages (up to 10-20 seconds to complete). During some of these I've had HS crash.
The first I'm aware of it is an error message from each of my plug-ins:
Run-time error '-2147418105 (80010007)':
Automation error
The callee (server [not server application]) is not avialble and disappeared; all connections are invalid. The call may have executed.
I get this from W800RF, DooMotion and DooNetwork in that order evey time. I respond OK to each of these and then this is followed with a HomeSeer error:
Run-time error '35606'
Control's collection has been modified.
Where do I start resolving this one guys?? My system's been fairly stable for months with the only recent changes being an updated DooMotion instalation and one replacememt ZWave lamp module that failed.
TIA
Malcolm
My HS (v1.7.44) completely crashes whilst waiting for the on command to complete. Most ZWave commands are successful instantly but I notice occaisonally some take ages (up to 10-20 seconds to complete). During some of these I've had HS crash.
The first I'm aware of it is an error message from each of my plug-ins:
Run-time error '-2147418105 (80010007)':
Automation error
The callee (server [not server application]) is not avialble and disappeared; all connections are invalid. The call may have executed.
I get this from W800RF, DooMotion and DooNetwork in that order evey time. I respond OK to each of these and then this is followed with a HomeSeer error:
Run-time error '35606'
Control's collection has been modified.
Where do I start resolving this one guys?? My system's been fairly stable for months with the only recent changes being an updated DooMotion instalation and one replacememt ZWave lamp module that failed.
TIA
Malcolm