I'm looking for help to verify my NX-584e is configured correctly to communicate with the Caddx plug in. I sent an email to Rien, but while waiting for a response I thought I'd ask this group to help troubleshooting with the module.
I'm a reasonably technical guy, but totally new at alarm programming so I need some very basic instructions. I had my alarm guy install the module in an NX-8V2, but he seemed to not be sure what he was doing.
Could someone either 1) provide instructions on how I can verify that its correctly configured (basic instructions please); or 2) point me to instructions where I can start over?
I gave the alarm guy the printout from here: http://board.homeseer.com/showthread.php?t=99873
Thanks for your help.
I'm a reasonably technical guy, but totally new at alarm programming so I need some very basic instructions. I had my alarm guy install the module in an NX-8V2, but he seemed to not be sure what he was doing.
Could someone either 1) provide instructions on how I can verify that its correctly configured (basic instructions please); or 2) point me to instructions where I can start over?
I gave the alarm guy the printout from here: http://board.homeseer.com/showthread.php?t=99873
Thanks for your help.
Comment