All of the thermometer devices on my system now use the new contemporary graphics, except for Ultra1Wire3 and UltraECM. Would it be possible to provide a means to mass change all the devices to use the new contemporary thermometer sets? Even a one-off script would be fine. I could edit the 40+ devices one-by-one but it would be nice to be able to add the range of HS3 icons to the temperature devices in these plug-ins.
If this is your first visit, be sure to check out the FAQ. You must register before you can post.
IMPORTANT: Your first post will be checked for appropriate content. This may take a bit of time.
- If your post is deemed to be spam-free and relevant to the community, it will be approved and you'll be able to post freely here.
- If your post is deemed to be spam, your post will be deleted and your account will be permanently banned.