Ultra,
I have moved my gas meter counter from the one wire network (Ultra1Wire3) to the Brultech GEM pulse counter channles (UltraECM3).
But I have small problem. In Ultra1Wire3 you could set the resolution of the pulse in the Ultra1Wire3 tab on the device configuration:
But in UltraECM3 there is nothing in the tab for the device configuration. This means the counter is out by a factor of 100. And for the water meter that I have just installed each pulse equals 0.5 litres.
It would be nice to be able to get the counter to align with the meter readings using the resolution. I use the 'value offset' in the status graphics tab to 'calibrate' the meter and the counter....if the resolution is taken in to account.
Would this be possible? Or too much work?
Marty
I have moved my gas meter counter from the one wire network (Ultra1Wire3) to the Brultech GEM pulse counter channles (UltraECM3).
But I have small problem. In Ultra1Wire3 you could set the resolution of the pulse in the Ultra1Wire3 tab on the device configuration:
Sensor Subtype: Gas Meter
Sensor Resolution: 1 pulse equals 0.01
Sensor Resolution: 1 pulse equals 0.01
It would be nice to be able to get the counter to align with the meter readings using the resolution. I use the 'value offset' in the status graphics tab to 'calibrate' the meter and the counter....if the resolution is taken in to account.
Would this be possible? Or too much work?
Marty