As the title says, I am missing a homeseer device for a load. It is in enabled in settings but doesnt show up in status anywhere. And further when I change a name of load in Ultra Ecm, the device does not change?
Announcement
Collapse
No announcement yet.
Missing Homeseer device for a load
Collapse
X
-
Originally posted by mattdb View PostAs the title says, I am missing a homeseer device for a load. It is in enabled in settings but doesnt show up in status anywhere. And further when I change a name of load in Ultra Ecm, the device does not change?
The channel (load) device name is only used when the HomeSeer device is created. I'll look at providing a synchronization option in the next release.
Regards,
UltrajonesPlug-ins: UltraMon, UltraM1G, UltraCID, Ultra1Wire, UltraLog, UltraWeatherBug, UltraPioneerAVR, UltraGCIR
-
Originally posted by mattdb View PostChannel 24 is missing in the devices. I was going to setup an event and low and behold I couldn't find it. I tried unchecking everything and the saving and then checking them again in channels, but that didn't do anything.
Thx for the help.
Mattman
Comment
-
Originally posted by mattdb View PostI did some digging and found the device in device manager watching the loads. It was there just named something different than what is in the plugin.
Comment
Comment