Only recognizes one housecode

[Spectrum]

Well, I had the whole world stop working a couple of weeks ago. It turned out to be my coupler repeater eating the X10 signal. Yes. I'm still using X10. I replaced it with a smaller coupler/repeater. I also replaced my Ocelot with a Ti102 Serial.

Now the system only sees one house code: C. When I send a signal from an M (my motion sensors) or my G (Garage), the signal meter bounces around but HS doesn't seem to see it.

Any ideas here?

John

[Spectrum]

OK. Update. Removed the Ti103 and put the old Ocelot back on. Now it recognizes my M code. Maybe the problem is solved. I did post another thread about switching away from x10 though.

Thanks.