Hi,
I have the Vista 20 panel and the A2USB connected and I can activate the alarm with its multiple modes such as (Activate stay, Activate Away, Deactivate).
I have a zone in my house without a Motion sensor, I installed a Aeotec Multisensor 6 in this zone and wanted to activate the "panic" mode with an event using the following:
If VistaPanel is "activated away"
AND If Motion is detected
Then....Control a Device...Vista Panel...however there is no option only to "turn the Audible Alarm as defined in the panic functions".
The manual states the following:
To activate Panic Function.- Press and hold at least 2 seconds whichever lettered key on the keypad that has been programmed for the desired emergency function.
how do we trigger these panic functions?
Thanks
Chris
I have the Vista 20 panel and the A2USB connected and I can activate the alarm with its multiple modes such as (Activate stay, Activate Away, Deactivate).
I have a zone in my house without a Motion sensor, I installed a Aeotec Multisensor 6 in this zone and wanted to activate the "panic" mode with an event using the following:
If VistaPanel is "activated away"
AND If Motion is detected
Then....Control a Device...Vista Panel...however there is no option only to "turn the Audible Alarm as defined in the panic functions".
The manual states the following:
To activate Panic Function.- Press and hold at least 2 seconds whichever lettered key on the keypad that has been programmed for the desired emergency function.
how do we trigger these panic functions?
Thanks
Chris
Comment