Announcement

Collapse
No announcement yet.

Setup polling

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Setup polling

    I have one of the hs-ms100+ sensors in my garage to activate the lights at night when the car pulls in. I have the events set so that the motion/no motion correctly activates the appropriate event to turn on/off the light and set a occupied/unoccupied virtual device. The problem lies with when the light switch is manually activated. I have a separate event that controls this based on how long the occupied/unoccpied virtual device has been in unoccupied status. The problem is when the sensor is in no motion and the room is "unoccupied". The event tied to the manual switch push also sets the occupied status virtual device to occupied and then the lights never will go over because the sensor does not change from no event until the next motion is detected and it reverts. Is there a setting on the sensor that I can change to have it update the status in homeseer every 30 minutes or something? I have it plugged into a wall outlet so battery life is not an issue.
Working...
X