Feature request.
Problem: Many LED bulbs will not turn on, or will take a few seconds to turn on, when going from off to a very low dim level even though they will dim to that exact same level.
Solution: Whenever a HS-WD100 state is changed from off to a value less than a set amount, should be programmable, drive the output to a higher level, should also be programmable, for at least one full AC cycle. This will give the LEDs electronics a chance to charge up.
This option should have a parameter to turn it on or off.
This is considerably different than having a minimum dim level option although they do complement each together.
Problem: Many LED bulbs will not turn on, or will take a few seconds to turn on, when going from off to a very low dim level even though they will dim to that exact same level.
Solution: Whenever a HS-WD100 state is changed from off to a value less than a set amount, should be programmable, drive the output to a higher level, should also be programmable, for at least one full AC cycle. This will give the LEDs electronics a chance to charge up.
This option should have a parameter to turn it on or off.
This is considerably different than having a minimum dim level option although they do complement each together.
Comment