I'm very new to Homeseer, but I'm evaluating the trial version to see if it works with my existing X10 kit before moving on to use it with Z-Wave.
So, I have a CM15A interface, and I also use SS13A switches to trigger events. I'm struggling to understand how I can trigger an event from pressing one of the buttons on the SS13A.
If I look in the HS3 log (having enabled X10 logging), I see this when I press one of the buttons:
CM15A DEBUG Received CM15 Address:B3, Command: on
So, I setup an Event as follows:
If CM15A: Recieve Command
House Code B Unit Code 3 Command ON
Then
Speak "Button 3 turned on"
But nothing happens. Am I correct to be using the CM15A: Receive Command option for this, or is there something else I need to enable to get this event to work?
So, I have a CM15A interface, and I also use SS13A switches to trigger events. I'm struggling to understand how I can trigger an event from pressing one of the buttons on the SS13A.
If I look in the HS3 log (having enabled X10 logging), I see this when I press one of the buttons:
CM15A DEBUG Received CM15 Address:B3, Command: on
So, I setup an Event as follows:
If CM15A: Recieve Command
House Code B Unit Code 3 Command ON
Then
Speak "Button 3 turned on"
But nothing happens. Am I correct to be using the CM15A: Receive Command option for this, or is there something else I need to enable to get this event to work?
Comment