I installed RaspberryIO plugin on my RasPi3, following all instructions. It does show up in 'Remote Plug-Ins' section in my HS3, saying ok and showing correct IP address.
I configure all pins to 'output', but when I change the state in HS - the pin states don't become 'hi' on Raspi.
I tested GPIO with RPi.GPIO - all works.
I also noticed that 'Toggle' option works only when output is 'on' - so it goes 'off'. But when it's 'off' - toggle doesn't do anything.
So, what's wrong? Please help...
I configure all pins to 'output', but when I change the state in HS - the pin states don't become 'hi' on Raspi.
I tested GPIO with RPi.GPIO - all works.
I also noticed that 'Toggle' option works only when output is 'on' - so it goes 'off'. But when it's 'off' - toggle doesn't do anything.
So, what's wrong? Please help...
Comment