These lines
indicate that the plugin connected to the Raspberry Pi, but that the Zwave controller was unresponsive, as Home ID/Node is the first thing the plugin tries to get.
When it gets into this state, ssh into the znet and issue this command
netstat -t
and post results.
This will tell us if there is an existing connection which isn't exiting properly. This is what the patch is supposed to prevent. If there isn't a lingering connection, my best guess would be that the UZB (the external zwave controller) is faulty.
Code:
Jan-20 12:17:06 Z-Wave Error zBrockhill: The zBrockhill interface did not respond to the request for the HomeID and Node - it may be disconnected or malfunctioning (2). Jan-20 12:15:51 Z-Wave zBrockhill: Z-Wave Ethernet at IP 192.168.0.150, connected to interface ok.
When it gets into this state, ssh into the znet and issue this command
netstat -t
and post results.
This will tell us if there is an existing connection which isn't exiting properly. This is what the patch is supposed to prevent. If there isn't a lingering connection, my best guess would be that the UZB (the external zwave controller) is faulty.
Comment