Longtime 1.4-1.7 user, just upgraded to 2.0 (fresh install). When I try to set the configuration of the plug-ins ("config" buttons on the Interfaces screen), nothing happens. Specifically,
--For the CM11a interface - the interface screen just refreshes.
--For the Caddx plugin, the message "Calling ConfigIO for Caddx plug-in" pops up from the tray, but the interface screen stays the same.
--For UltraLog pluging, similar to Caddx (says "calling ConfigIO for ultralog") bit again no change in the interface screen.
Suggestions, please. I searched the forums for "plugin config" but didn't find anything applicable.
--For the CM11a interface - the interface screen just refreshes.
--For the Caddx plugin, the message "Calling ConfigIO for Caddx plug-in" pops up from the tray, but the interface screen stays the same.
--For UltraLog pluging, similar to Caddx (says "calling ConfigIO for ultralog") bit again no change in the interface screen.
Suggestions, please. I searched the forums for "plugin config" but didn't find anything applicable.
Comment