I have a SIIG 2-port USB to Serial Converter, the same one that HS sells as the HS2012, though I purchased elsewhere.
Anyway, has anyone else had a problem with it being recognized as an "Unkown Device" after a reboot? I have my W800 and Ztroller connected to it, using COMs 5 & 6 respectively, and after X reboots, the ports disappear and the convertor becomes an "Unknown Device" Only a compelte shutdown (which removed power from the device) will make it become recognized again. It's as if it does not always recover gracefully from a soft reboot.
I've had it for about 4 months, and this problem just started in the last month. I'm wondering if this is typical, or if my unit's going bad.
Anyway, has anyone else had a problem with it being recognized as an "Unkown Device" after a reboot? I have my W800 and Ztroller connected to it, using COMs 5 & 6 respectively, and after X reboots, the ports disappear and the convertor becomes an "Unknown Device" Only a compelte shutdown (which removed power from the device) will make it become recognized again. It's as if it does not always recover gracefully from a soft reboot.
I've had it for about 4 months, and this problem just started in the last month. I'm wondering if this is typical, or if my unit's going bad.
Comment