Hi Greig, I've just installed v32 and recreated all my devices.
If I switch a PWM device to Full using the gui, then it constantly fades up to 100%, then immediately switches off and starts fading up to 100% again. So I get a flashing light.
If I set the device to 99% then it behaves normally and is constantly at 99%
any ideas?
cheers
If I switch a PWM device to Full using the gui, then it constantly fades up to 100%, then immediately switches off and starts fading up to 100% again. So I get a flashing light.
If I set the device to 99% then it behaves normally and is constantly at 99%
any ideas?
cheers
Comment