Whenever I bypass a zone I get the error shown below in the log. However, it does bypass the zone as requested (and can be seen by accessing zones on DSC keypad).
Any idea what's up?
Feb-19 2:52:09 PM EnvisaLink WARNING Unknown command value = 616
Feb-19 2:52:09 PM EnvisaLink INFO Partition 1 status change: Ready
Feb-19 2:52:07 PM Device Control Device: EnvisaLink Alarm 12 - Garage South Motion Sensor to Bypass (-1000) by/from: CAPI Control
Any idea what's up?
Feb-19 2:52:09 PM EnvisaLink WARNING Unknown command value = 616
Feb-19 2:52:09 PM EnvisaLink INFO Partition 1 status change: Ready
Feb-19 2:52:07 PM Device Control Device: EnvisaLink Alarm 12 - Garage South Motion Sensor to Bypass (-1000) by/from: CAPI Control
Comment