I just downloaded and installed your plug-in to try it out with my UPB network, hoping you will soon support the new Pulse Worx Ethernet Gateway. Currently I am using a Simply Automated PIM on Com1.
Anyway, after disabling the HS plug-in and after a smooth install of your plug-in with a successful read of my .upe file, all my UPB devices were non-responsive. I tried restarting HS3 and then rebooting my hometroller but still all the UPB devices were non-responsive in HS3. I got nervous so I disabled your plug-in and enabled the HS plug-in and the UPB devices are now responsive in HS3.
Any ideas on why this might of happened?
Are you planning on supporting the new Pulse Worx Ethernet Gateway?
Thanks in advance
Anyway, after disabling the HS plug-in and after a smooth install of your plug-in with a successful read of my .upe file, all my UPB devices were non-responsive. I tried restarting HS3 and then rebooting my hometroller but still all the UPB devices were non-responsive in HS3. I got nervous so I disabled your plug-in and enabled the HS plug-in and the UPB devices are now responsive in HS3.
Any ideas on why this might of happened?
Are you planning on supporting the new Pulse Worx Ethernet Gateway?
Thanks in advance
Comment