Is there a relatively easy way to keep a Keypad's buttons in sync with the devices they control? I mainly see the issue when I send the Global OFF command at midnight. I use this to insure all the lights are off. However, this command does not turn off the button lights. So in the morning the keypads are in whatever state they were in at midnight. In my HS2 setup, I ran an event after midnight that turned each and every keypad off manually. This was quite tedious and I was hoping that there was a better way for HS3.
I also see this whenever I turn a device on/off via HS3 vs. using an actual device. The keypad button will not change to the corresponding state of the responder.
I though about setting up an event for each device that is controlled by a keypad button and then have the event change the button state. But that is even more work.
Looking for suggestions as I'm sure others have tried to deal with this problem.
I also see this whenever I turn a device on/off via HS3 vs. using an actual device. The keypad button will not change to the corresponding state of the responder.
I though about setting up an event for each device that is controlled by a keypad button and then have the event change the button state. But that is even more work.
Looking for suggestions as I'm sure others have tried to deal with this problem.
Comment