Summer is closing in and I once again wanted to get my Rain8 Pro module up and running using HomeSeer3, but it fails.
No error though.
Steps taken:
1 activate plugin
2 configure plugin for 1 master & 4 zones
3 test plugin by activating a zone.
Now these steps are working fine. The problem occurs when I pres the next capi action. Now nothing happens.
mai-23 19:24:46 Device Control Device: Not Set Not Set IO1 to Off (4) by/from: CAPI Control Handler
mai-23 19:24:41 Device Control Device: Not Set Not Set IO1 to On (3) by/from: CAPI Control Handler
mai-23 19:24:31 Device Control Device: Not Set Not Set IO1 to Off (4) by/from: CAPI Control Handler
mai-23 19:24:27 Device Control Device: Not Set Not Set IO1 to On (3) by/from: CAPI Control Handler
mai-23 19:24:18 Plug-In Finished initializing plug-in Rain8
It's irrelevant what first action I'm doing. after restart of plugin.
So if I disable the plugin and enable it again I can issue one action. E.G Pull and all statuses are updated, but when I later press on for one zone nothing happens.
previously my setup have been working ok using HS2, Please advice, I want to get HS3 up and running.
No error though.
Steps taken:
1 activate plugin
2 configure plugin for 1 master & 4 zones
3 test plugin by activating a zone.
Now these steps are working fine. The problem occurs when I pres the next capi action. Now nothing happens.
mai-23 19:24:46 Device Control Device: Not Set Not Set IO1 to Off (4) by/from: CAPI Control Handler
mai-23 19:24:41 Device Control Device: Not Set Not Set IO1 to On (3) by/from: CAPI Control Handler
mai-23 19:24:31 Device Control Device: Not Set Not Set IO1 to Off (4) by/from: CAPI Control Handler
mai-23 19:24:27 Device Control Device: Not Set Not Set IO1 to On (3) by/from: CAPI Control Handler
mai-23 19:24:18 Plug-In Finished initializing plug-in Rain8
It's irrelevant what first action I'm doing. after restart of plugin.
So if I disable the plugin and enable it again I can issue one action. E.G Pull and all statuses are updated, but when I later press on for one zone nothing happens.
previously my setup have been working ok using HS2, Please advice, I want to get HS3 up and running.
Comment