Announcement

Collapse
No announcement yet.

Smartwares RM174RF/2

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Smartwares RM174RF/2

    This afternoon I have been trying to setup my new smartwares smoke detectors (type RM174RF/2). After updating my rfxtrx433e to the latest EXT2 firmware I still can't find the right way to add them to homeseer. According to the manual the detectors have a sending mode. But even when activating this mode I don't see any new RM174RF devices showing in the RFXCOM input devices list.

    Any ideas?

    Regards,

    #2
    Please check with RFXmngr if the sensor is received.
    Use Ext2 firmware and enable the ARC protocol.

    Comment


      #3
      Thanks for the quick reply Bert,

      The smoke detector was indeed received as I can see in rfxmanager. I now found the device code and added the device on the security input screen.

      Is there also a battery status received, or only the panic mode? I could not find any other signals from the device in rfxmanager...

      Regards,

      Comment


        #4
        The RM174RF does not transmit a battery status by RF.

        Comment


          #5
          Thanks Bert,

          Is there any documentation about the learning process for the RM174RF? I can't pair the smoke detectors from HS3 to activate them. Also tried to pair it with rfxmanager, but no succes yet...

          Regards,

          Comment

          Working...
          X