Hope I can explain it understandable...
With the plugin 3.0.0.19 the IH widget is working as it should with one important issue: if I want to change the heating setpoint from e. 18c to 21c I have to push the Up arrow 6 times (0.5c steps). Each time a value gets added to the z-wave waikup queue. When the LC13 walks up, than it gets flushed with the different values and in some cases the LC13 just stops working.
To prevent this, the IH widget should only send a new heating setpoint after a 2s delay after the last entry. I guess this could be done in the IH itself or on the IH plugin.
Any thoughts on this?
Rgds,
Ulrich
With the plugin 3.0.0.19 the IH widget is working as it should with one important issue: if I want to change the heating setpoint from e. 18c to 21c I have to push the Up arrow 6 times (0.5c steps). Each time a value gets added to the z-wave waikup queue. When the LC13 walks up, than it gets flushed with the different values and in some cases the LC13 just stops working.
To prevent this, the IH widget should only send a new heating setpoint after a 2s delay after the last entry. I guess this could be done in the IH itself or on the IH plugin.
Any thoughts on this?
Rgds,
Ulrich
Comment