DESCRIPTION
Plug-in for the Smart Meters that are currently being installed all over The Netherlands (and possibly other European countries?) Requires a special Serial or USB to P1 (RJ11) cable.
REQUIREMENTS
INSTALLATION
There are no additional software requirements. The plug-in can be installed from the HS3 updater, and can be found under the section “Energy Management”.
CONFIGURATION
After installation and starting the plug-in, go to the configuration page. They are five tabs:
TROUBLESHOOTING
There is not much troubleshooting. If things don't work, you either have the wrong cable, or the wrong port settings.
Plug-in for the Smart Meters that are currently being installed all over The Netherlands (and possibly other European countries?) Requires a special Serial or USB to P1 (RJ11) cable.
REQUIREMENTS
- This plugin is for HS3 or HS3PRO. It works with both Windows and Linux versions
- .NET Framework 4.5 or later, or mono 4.x needs to be installed on your Homeseer machine
- equires a special Serial or USB to P1 (RJ11) cable. See table below for the correct cable layout.
Or just search the Internet for a P1 interface cable. It should look similar to this:
INSTALLATION
There are no additional software requirements. The plug-in can be installed from the HS3 updater, and can be found under the section “Energy Management”.
CONFIGURATION
After installation and starting the plug-in, go to the configuration page. They are five tabs:
- Port Settings: Make sure the settings match the Smart Meter installed.
- General: Set the update frequency (1 minute is usually fine) and if you want the daily totals to reset at midnight.
- Energy: Settings to configure the HS3 build-in energy graphic
- Debug: Enable advanced logging, normally disabled
- Support: How to get support and how to donate
TROUBLESHOOTING
There is not much troubleshooting. If things don't work, you either have the wrong cable, or the wrong port settings.
Comment