Here disabled plugin first and removed all system variables then re enabled plugin and let the Omni plugin recreate all of the variables.
Note here using central services with a primary copper phone line. Putting it in test mode with CO when testing.
Going slower here testing as well as I can test here...so baby steps here...
[ATTACH]67694[/ATTACH]
- disconnected phone at RJ11 - no dialtone on phone as expected - Omni Panel Phone LED lamp on - Phone line dead trouble on keypad, no changes in system status above for phone, communicator and DCM. Note: there have been no changes in system variables (except for battery going to zero) since around 9:20 / 9:36 AM this morning.
Note here using central services with a primary copper phone line. Putting it in test mode with CO when testing.
Going slower here testing as well as I can test here...so baby steps here...
[ATTACH]67694[/ATTACH]
- Battery - showed voltage of 13.XX here for a bit - picked up the phone and went to zero and stayed there.
- Freeze
- ac
- phone - never changes with phone line dead trouble
- communicator
- codes
- bell
- fuse
- dcm - alway shows at fault
- connection
- disconnected phone at RJ11 - no dialtone on phone as expected - Omni Panel Phone LED lamp on - Phone line dead trouble on keypad, no changes in system status above for phone, communicator and DCM. Note: there have been no changes in system variables (except for battery going to zero) since around 9:20 / 9:36 AM this morning.