Thought I had my preferred settings dialed in on the MS6 units... but going through the docs on the Z-Wave site (http://products.z-wavealliance.org/p...s/1810/configs) I'm curious if anyone's using the "selective reporting only when measurements reach a certain threshold" config?
If so, would that make it more viable to run much shorter reporting rates but not expect them to be a problem if there's no changes?
Any idea what affect this has? Or is it just time to experiment?
If so, would that make it more viable to run much shorter reporting rates but not expect them to be a problem if there's no changes?
Any idea what affect this has? Or is it just time to experiment?
Comment