I am trying to rebuild my Z-wave network. After a bit of frustration and much learning, I have my USB stick (HA22) with all devices added via Z-Tool. I have put the stick back in the HomeTroller and did the Load function, several times. It kept showing only five nodes of my eight node network. Eventually I went back under setup and the Z-wave network showed all eight nodes. When I go to the status page, there are still only five nodes showing... making it hard to program my Christmas lights to come on with a Time Trigger.
My SmartLinc interface is also not operating my X-10 devices, but that's another story.
Any thoughts or ideas are greatly appreciated.
My SmartLinc interface is also not operating my X-10 devices, but that's another story.
Any thoughts or ideas are greatly appreciated.
Comment