I am struggling to get new MS100+ Sensor to connect to SEL.
Steps so far:
Upgraded z-wave to 3.0.1.184 (as recommend by others having challenge)
Have removed sensor and add 3 times. Consistent results. Did non-secure inclusion.
I see Root Device
Home Security
Battery.
When I try to connect in any way, I get: "Failed getting InterfaceStatus from Z-Wave - the interface was not found in the list of active interfaces, the list may need to be refreshed".
It does show blue light and motion for the first minute. Then no light. I have tried battery only, and connecting by micro usb.
Any ideas? Next step is to return as bad and try again.
thanks!
Steps so far:
Upgraded z-wave to 3.0.1.184 (as recommend by others having challenge)
Have removed sensor and add 3 times. Consistent results. Did non-secure inclusion.
I see Root Device
Home Security
Battery.
When I try to connect in any way, I get: "Failed getting InterfaceStatus from Z-Wave - the interface was not found in the list of active interfaces, the list may need to be refreshed".
It does show blue light and motion for the first minute. Then no light. I have tried battery only, and connecting by micro usb.
Any ideas? Next step is to return as bad and try again.
thanks!
Comment