OMNI Problem-1 - Message Board - Current Date/Time: 3/10/2018 3:37:47 PM
I was having major problems with OMNI Plug-in Dropping out and then restarting.
Researched the problem, and changed out the LAN switch to 100/10, Dropouts have stopped.
BUT the Plug-in does not respond to changes in the OmniPro II?
I created 3 Omni flags ARM, DisARM and ALARM and they change accordingly -
Created the same Virtual FLAGS- in HS w/no changes upon OMNI change of state?
All are activated in HS
I worked with Homeseer in the early 80's and it was better than Compact computers,
OMNI was on a serial connection.
Any Help would be Appreciated!
Charles
HomeSeer Platform S6PRO, HS3 Pro Edition 3.0.0.368
Operating System: Microsoft Windows 10 Home - Work Station
System Up time: 2 Days 7 Hours 52 Minutes 20 Seconds
IP Address: 192.168.1.195
Number of Devices: 278
Number of Events: 234
Available Threads: 200
Enabled Plug-Ins
3.0.0.97: LutronRA2
3.0.2.5: OMNI
3.0.0.42: UPBSpud
3.0.1.190: Z-Wave
Plus others that are not enabled yet.
I was having major problems with OMNI Plug-in Dropping out and then restarting.
Researched the problem, and changed out the LAN switch to 100/10, Dropouts have stopped.
BUT the Plug-in does not respond to changes in the OmniPro II?
I created 3 Omni flags ARM, DisARM and ALARM and they change accordingly -
Created the same Virtual FLAGS- in HS w/no changes upon OMNI change of state?
All are activated in HS
I worked with Homeseer in the early 80's and it was better than Compact computers,
OMNI was on a serial connection.
Any Help would be Appreciated!
Charles
HomeSeer Platform S6PRO, HS3 Pro Edition 3.0.0.368
Operating System: Microsoft Windows 10 Home - Work Station
System Up time: 2 Days 7 Hours 52 Minutes 20 Seconds
IP Address: 192.168.1.195
Number of Devices: 278
Number of Events: 234
Available Threads: 200
Enabled Plug-Ins
3.0.0.97: LutronRA2
3.0.2.5: OMNI
3.0.0.42: UPBSpud
3.0.1.190: Z-Wave
Plus others that are not enabled yet.