Anyone that knows how to stop the excessive traffic from Insteon please chime in. Seems every command is follow by a crazy amount of blinking.
Ive gone through and deleted unnecessary lincs and such.
Its hard to keep up with the latest firmware because of smartlincing.
I'm not sure what to do (or should I not worry). Most of the communication is valid (no red blinking on devices) but the diagnostic keypad buzzes every now and again.
I read that maybe the hub is searching for absent devices or scenes.
I have deleted some scenes, however no devices are absent.
I dread a system reset.
Current Date/Time: 3/18/2018 1:41:12 PM
HomeSeer Version: HS3 Pro Edition 3.0.0.368
Operating System: Microsoft Windows 10 Pro - Work Station
System Uptime: 0 Days 3 Hours 14 Minutes 14 Seconds
IP Address: 192.168.0.104
Number of Devices: 349
Number of Events: 27
Available Threads: 1023
Enabled Plug-Ins
3.0.0.37: EnvisaLink
3.7.0.0: Harmony Hub
3.7.0.0: Harmony Hub
3.0.6.16: Insteon
2.0.1.6: JowiHue
3.0.0.14: NetCAM
3.3.6389.22764: Yamaha
Ive gone through and deleted unnecessary lincs and such.
Its hard to keep up with the latest firmware because of smartlincing.
I'm not sure what to do (or should I not worry). Most of the communication is valid (no red blinking on devices) but the diagnostic keypad buzzes every now and again.
I read that maybe the hub is searching for absent devices or scenes.
I have deleted some scenes, however no devices are absent.
I dread a system reset.
Current Date/Time: 3/18/2018 1:41:12 PM
HomeSeer Version: HS3 Pro Edition 3.0.0.368
Operating System: Microsoft Windows 10 Pro - Work Station
System Uptime: 0 Days 3 Hours 14 Minutes 14 Seconds
IP Address: 192.168.0.104
Number of Devices: 349
Number of Events: 27
Available Threads: 1023
Enabled Plug-Ins
3.0.0.37: EnvisaLink
3.7.0.0: Harmony Hub
3.7.0.0: Harmony Hub
3.0.6.16: Insteon
2.0.1.6: JowiHue
3.0.0.14: NetCAM
3.3.6389.22764: Yamaha
Comment