Announcement

Collapse
No announcement yet.

blink and flash

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    blink and flash

    On the guide i read:
    Output: Outputs can be controlled in the following way:
    On: Turns the output High
    Off: Turns the output Low
    Blink: This will Blink the output on and off at the time set by the Output Time device for the given pin
    One Flash: This will Set the Output High then Low using the time set by the Output Time device for the
    given pin
    But where I can set "the Output Time device for the given pin"?

    #2
    There should be a device for each output time. If you dont see them then check your device type filter. See screenshot below.

    Greig.
    Attached Files
    Zwave = Z-Stick, 3xHSM100� 7xACT ZDM230, 1xEverspring SM103, 2xACT HomePro ZRP210.
    X10 = CM12U, 2xAM12, 1xAW10, 1 x TM13U, 1xMS13, 2xHR10, 2xSS13
    Other Hardware = ADI Ocelot + secu16, Global Cache GC100, RFXtrx433, 3 x Foscams.
    Plugings = RFXcom, ActiveBackup, Applied Digital Ocelot, BLDeviceMatrix, BLGarbage, BLLAN, Current Cost, Global Cache GC100,HSTouch Android, HSTouch Server, HSTouch Server Unlimited, NetCAM, PowerTrigger, SageWebcamXP, SqueezeBox, X10 CM11A/CM12U.
    Scripts =
    Various

    Comment


      #3
      Originally posted by enigmatheatre View Post
      If you dont see them then check your device type filter. See screenshot below.

      Greig.
      Thanks Greig, filter was my problem! (I tried the solution into "arduino plugin config")

      Comment

      Working...
      X