Announcement

Collapse
No announcement yet.

Zseer+ - All nodes fail response test

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Zseer+ - All nodes fail response test

    I installed Zseer+ and tested my network. All nodes fail with the response test. The command test pass with no failed commands but not a single response goes through, I get an error:

    Testing node 8...
    Issue getting node level : Timeout OK

    I get this error for every node but only for response tests. I use an HS3 ZEE S2 Edition 3.0.0.318 with version 3.0.1.130 of the zwave plugin.

    Any suggestions on how to fix this?

    Thanks!

    #2
    Same problem.

    I just bought Zseer+ hoping it might help me with some zwave issues. I ran it and it is telling me that over half my currently installed devices cannot be found. Same issues as rbeauch above.

    Testing node X...
    Issue getting node level : Timeout OK

    When I first fired it up, it says:

    Could not contact node X without routing
    Could not contact node X at all

    I had two dimmers unplugged so I get that they could not be contacted, but 35 others? If the network cannot contact them, how do events get completed.

    When I click on documentation, nothing happens so I am unsure what this really means. I run reports and nothing happens. What can you actually do with Zseer+??

    I am a newbie to zwave, so if this is a dumb question, please feel free to let me know! :-)

    Rob
    .

    Comment

    Working...
    X