Spud,
Just installed my two last thermostat and I'm getting incomplete polls for them :
Unit #9 : Control mode is not reporting
Unit #10 : 3 out 9 values seemed to have polled one time and are not being updated since then. See attached capture and it is 17:01 right now.
What I tried :
- Restart HS and PI
- Rebuild network on Neviweb.
- Delete and recreate #10 in HS
- Changing the poll time from 1 to 2
Note 1: All units are interacting normally in Neviweb.
Note 2: If I change the setpoint via HS, the value is going thru.
Strange to see this with the 10th unit?
Running V3.0.0.8
Let me know if you want me to check something in particular.
Just installed my two last thermostat and I'm getting incomplete polls for them :
Unit #9 : Control mode is not reporting
Unit #10 : 3 out 9 values seemed to have polled one time and are not being updated since then. See attached capture and it is 17:01 right now.
What I tried :
- Restart HS and PI
- Rebuild network on Neviweb.
- Delete and recreate #10 in HS
- Changing the poll time from 1 to 2
Note 1: All units are interacting normally in Neviweb.
Note 2: If I change the setpoint via HS, the value is going thru.
Strange to see this with the 10th unit?
Running V3.0.0.8
Let me know if you want me to check something in particular.
Comment