Hi all
I have recently installed a HAI RC-80 thermostat and have it communicating fine with the homeseer hai plugin. I can send commands to the thermostat and heater turns on/off etc. The only problem is that it displays the outside temperature as 0 degrees. I have the box ticked in my setup to use one of my 1 wire temp sensors as the outside temp reading from data I import to homeseer via weather display. I have tried a couple of rebooting and power off combinations, but still no luck.
Anyone else had a similar problem?
I am running Homeseer 2.1.28
Cheers
Andy
I have recently installed a HAI RC-80 thermostat and have it communicating fine with the homeseer hai plugin. I can send commands to the thermostat and heater turns on/off etc. The only problem is that it displays the outside temperature as 0 degrees. I have the box ticked in my setup to use one of my 1 wire temp sensors as the outside temp reading from data I import to homeseer via weather display. I have tried a couple of rebooting and power off combinations, but still no luck.
Anyone else had a similar problem?
I am running Homeseer 2.1.28
Cheers
Andy
Comment