I am trying to program two RemoteLincs to control the same ceiling fan in our bedroom (one for me, one for the wife). The ceiling fan is X10, so I am using events.
I've created two events, Ceiling Fan On and Ceiling Fan Off. In both of them, the basic logic is supposed to be:
IF Jim's Remote changes and become ON (OFF)
OR IF Mary's Remote changes and becomes ON (OFF)
THEN turn on(off) ceiling fan.
The problem I am having is that with my remote, the event designer correctly gives me the choice of ON or OFF; however with Mary's remote, it only gives me a drop-down with the choices:
custom value or value range of
(Set to 'any value')
An invalid or error state.
Both Remotelincs are defined in the Insteon plug-in exactly the same. They both show the same firmware version. Why on earth does it give me different sets of choices for the two identical RemoteLincs?
I've created two events, Ceiling Fan On and Ceiling Fan Off. In both of them, the basic logic is supposed to be:
IF Jim's Remote changes and become ON (OFF)
OR IF Mary's Remote changes and becomes ON (OFF)
THEN turn on(off) ceiling fan.
The problem I am having is that with my remote, the event designer correctly gives me the choice of ON or OFF; however with Mary's remote, it only gives me a drop-down with the choices:
custom value or value range of
(Set to 'any value')
An invalid or error state.
Both Remotelincs are defined in the Insteon plug-in exactly the same. They both show the same firmware version. Why on earth does it give me different sets of choices for the two identical RemoteLincs?
Comment