Go Back   HomeSeer Message Board > Lighting & Primary Technology Plug-ins > Lighting & Primary Technology Discussion > HomeSeer Z-Wave Plug-in

HomeSeer Z-Wave Plug-in Discussions relating to the Z-Wave plug-in

Thread Tools Display Modes
Old December 28th, 2009, 10:49 PM
brbjr brbjr is offline
Join Date: Aug 2008
Location: Houston
Posts: 37
Failed sending Z-Wave command to device(s): Z-Wave Z-Wave Interface

I am getting theese errors 'Failed sending Z-Wave command to device(s): Z-Wave Z-Wave Interface '. Why doesn't homeseer try to send the command again when receiving this error. I can not replicate this error when using the controlthink sdk. If I try again it is sucessfull.

Any Ideas? Is there a way to make homeseer retry the command on failure?
Reply With Quote


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -4. The time now is 06:10 AM.

Copyright HomeSeer Technologies, LLC