I have searched, but cannot find out if it is possible and how to, have the LED indicator on the switch itself correspond to the light load. If the lights are on I would like the led on. I cannot see where to change that? Thanks.
Joe
Joe
If this is your first visit, be sure to check out the FAQ. You must register before you can post.
IMPORTANT: Your first post will be checked for appropriate content. This may take a bit of time.
- If your post is deemed to be spam-free and relevant to the community, it will be approved and you'll be able to post freely here.
- If your post is deemed to be spam, your post will be deleted and your account will be permanently banned.
Comment