I have tried to put an Xiaomi door sensor in my mailbox so I can become aware of when mail arrives, which does not happen every week.
It worked when I tested, but when I close the mailbox door (The one i open to take out the maill), it will not respond anymore.
If I open the door again, it will send status fine when open/close the letter tab.
So its probably has something to do with signal strength.
I see in DeCONZ that it is connected to my ConBee and not a HUE bulb that has half the distance to the mailbox.
I can not figure out how to make any manual route in DeCONZ, so it can be connected to the Hue bulb instead.
I have an Xiaomi Cube that is connected to the Hue bulbs so the Xiaomi devices can use Hue as a route.
Also has an Xiaomi door sensor connected to an Ikea bulb 10 times as far away as a Hue bulb. So do not quite understand the route that DeConz / ZigBee makes.
Can anyone help me make a manual route in DeCONZ?
It worked when I tested, but when I close the mailbox door (The one i open to take out the maill), it will not respond anymore.
If I open the door again, it will send status fine when open/close the letter tab.
So its probably has something to do with signal strength.
I see in DeCONZ that it is connected to my ConBee and not a HUE bulb that has half the distance to the mailbox.
I can not figure out how to make any manual route in DeCONZ, so it can be connected to the Hue bulb instead.
I have an Xiaomi Cube that is connected to the Hue bulbs so the Xiaomi devices can use Hue as a route.
Also has an Xiaomi door sensor connected to an Ikea bulb 10 times as far away as a Hue bulb. So do not quite understand the route that DeConz / ZigBee makes.
Can anyone help me make a manual route in DeCONZ?
Comment