Hi Spud and all
This bit of strangeness just started happening this morning and I can't figure it out.
I have a virtual device called "kitchen lights" (values 0-100) and an event that uses eztrigger to monitor that device for changes and then set the value of 5 dimmable lights in the kitchen to that new value. Been working rock solid for ages now. This morning, though, the lights only respond to 0 or 100, off or full on.
Set the log to debug and saw that setting the virtual device to any value from 1-99 did indeed set the lights to the same value, but then the lights all immediately changed back to zero. The virtual device, however, still shows the value I set.
Any idea why eztrigger is resetting values to zero? I disabled and enabled eztrigger, no joy.
Thanks in advance for any help/advice.
Tom
This bit of strangeness just started happening this morning and I can't figure it out.
I have a virtual device called "kitchen lights" (values 0-100) and an event that uses eztrigger to monitor that device for changes and then set the value of 5 dimmable lights in the kitchen to that new value. Been working rock solid for ages now. This morning, though, the lights only respond to 0 or 100, off or full on.
Set the log to debug and saw that setting the virtual device to any value from 1-99 did indeed set the lights to the same value, but then the lights all immediately changed back to zero. The virtual device, however, still shows the value I set.
Any idea why eztrigger is resetting values to zero? I disabled and enabled eztrigger, no joy.
Thanks in advance for any help/advice.
Tom
Comment