I was on the phone with Homeseer tech support a few days ago who were helping me get my smartstick configured, and at one point they told me to check a box to disable polling (because I was dealing with a z wave plus device that didn't need it).
I can't remember what it was for...whether a specific device, or the controller or what.
Now I'm trying to go back to unset what I had (not sure if it's causing other issues) and I can't find the checkbox. Where in the HS3 UI is a checkbox that says "enable polling"?
On a different (but related) note, I have a Homeseer motion/temp/luminance sensor and other devices that currently say their polling time is zero. Does that mean auto? or off?
I can't remember what it was for...whether a specific device, or the controller or what.
Now I'm trying to go back to unset what I had (not sure if it's causing other issues) and I can't find the checkbox. Where in the HS3 UI is a checkbox that says "enable polling"?
On a different (but related) note, I have a Homeseer motion/temp/luminance sensor and other devices that currently say their polling time is zero. Does that mean auto? or off?
Comment