I'm not even sure which sub-forum to post in, or for that matter if there's another forum that's better suited to my question.
I have a Hometroller Zee S2 with the Linear GD00Z garage controller working just fine. Now I want to program one of the group buttons to open or close the garage door and it doesn't work at all.
It appears the Zee sees me hitting buttons:
Feb-11 4:25:00 PMZ-Wave WarningInternal: Unhandled frame for command class: COMMAND_CLASS_WINDOW_COVERING Received on interface Internal Source Node: 8
Feb-11 4:25:00 PMZ-Wave WarningInternal : Secure message received from node 8. It was successfully decrypted but the data sequence ID is out of sequence. (Not Processed)
Feb-11 4:24:59 PMZ-WaveSecurity Z-Wave Root Garage Door Control signal received, polling node.
Feb-11 4:24:38 PMZ-WaveSecurity Z-Wave Root Garage Door Control signal received, polling node
I can assign other devices to the buttons and it works. Is the reason that the garage controller expects "open/close" instead of "on/off"? Something else?
Thoughts anyone?
I have a Hometroller Zee S2 with the Linear GD00Z garage controller working just fine. Now I want to program one of the group buttons to open or close the garage door and it doesn't work at all.
It appears the Zee sees me hitting buttons:
Feb-11 4:25:00 PMZ-Wave WarningInternal: Unhandled frame for command class: COMMAND_CLASS_WINDOW_COVERING Received on interface Internal Source Node: 8
Feb-11 4:25:00 PMZ-Wave WarningInternal : Secure message received from node 8. It was successfully decrypted but the data sequence ID is out of sequence. (Not Processed)
Feb-11 4:24:59 PMZ-WaveSecurity Z-Wave Root Garage Door Control signal received, polling node.
Feb-11 4:24:38 PMZ-WaveSecurity Z-Wave Root Garage Door Control signal received, polling node
I can assign other devices to the buttons and it works. Is the reason that the garage controller expects "open/close" instead of "on/off"? Something else?
Thoughts anyone?
Comment