Hello,
I've made a circuit for a fluxmeter based on the Z-uno device from Zwave>Me and the GA1A1S202WP device from AdaFruit.
I've added the corresponding sketch to show how the datatype is defined in the Z-uno device. (Adafruit-GA1A1S202WP.txt)
The electronics are working and are reporting the expected values. (see the serial monitor report of the arduino IDE)
But I can't match the right datatype in HS3 for the device value. The created device in HS3 when including the device into the z-wave network has apparently a 1 byte datatype. (see DeviceInfo3.png)
The device value is regulary refreshed but reports always 255 or 2,55(looks like it is overblown).
It looks like the Luminance device is always reporting it's max value of 255 (1byte).
How can I match the HS3 device value datatype to the one defined in the sketch (C# float (4bytes))?
thanks,
Joris
I've made a circuit for a fluxmeter based on the Z-uno device from Zwave>Me and the GA1A1S202WP device from AdaFruit.
I've added the corresponding sketch to show how the datatype is defined in the Z-uno device. (Adafruit-GA1A1S202WP.txt)
The electronics are working and are reporting the expected values. (see the serial monitor report of the arduino IDE)
But I can't match the right datatype in HS3 for the device value. The created device in HS3 when including the device into the z-wave network has apparently a 1 byte datatype. (see DeviceInfo3.png)
The device value is regulary refreshed but reports always 255 or 2,55(looks like it is overblown).
It looks like the Luminance device is always reporting it's max value of 255 (1byte).
How can I match the HS3 device value datatype to the one defined in the sketch (C# float (4bytes))?
thanks,
Joris
Comment