I had my power bounce this morning and when it came back up my Z-NET has stopped working. I tried rebooting and it still is not working. I can see the device on the network but the green light on the z-wave module is not on.
I hooked a monitor to it and rebooted and I'm seeing an error message.
"Unable to determine hardware version. I see: Hardware : BCM2835
- expecting BCM2708 or BCM2709
If this is a genuine Raspberry Pi then please report thia
to project@dragon.net. If this is not a Raspberry Pi then you
are on your own as wiringPI is designed to support the
Raspberry Pi ONLY.
[FAILED] Failed to start /etc/rc.local Compatibility."
Any help would be appreciated
I hooked a monitor to it and rebooted and I'm seeing an error message.
"Unable to determine hardware version. I see: Hardware : BCM2835
- expecting BCM2708 or BCM2709
If this is a genuine Raspberry Pi then please report thia
to project@dragon.net. If this is not a Raspberry Pi then you
are on your own as wiringPI is designed to support the
Raspberry Pi ONLY.
[FAILED] Failed to start /etc/rc.local Compatibility."
Any help would be appreciated
Comment