Just testing one Omnistat 1000 here with V.26 of Omni Plugin. It is serially connected to the OmniPro 2 panel.
Omnitouch thermostat screens (very simple) reflect status fine.
Removed Thermostat1 variables, disabled and re-enabled thermostat config switch to test where it recreated all Homeseer 3 variables.
[ATTACH]67693[/ATTACH]
Here primarily watch but never change thermostat such that mostly only use status of thermostat for Homeseer - Homeseer touch.
Omnitouch thermostat screens (very simple) reflect status fine.
Removed Thermostat1 variables, disabled and re-enabled thermostat config switch to test where it recreated all Homeseer 3 variables.
[ATTACH]67693[/ATTACH]
Here primarily watch but never change thermostat such that mostly only use status of thermostat for Homeseer - Homeseer touch.
- Thermostat 1 Root Device - if I remove this device all of the rest of the Thermostat 1 devices also get removed - suppose that this is normal
- Humidity - not utilized
- Operating State - appears to be working fine and changes when Heat starts and shuts off.
- Heating Setpoint - appears to work fine when changing heating setpoint on thermostat
- Cooling Setpoint - have not touched it at this time.
- Mode - have turned it on or off and appears to work fine
- Humidity Setpoint - not touched
- Dehumidify Setpoint - not touched
- Fan Mode - appears to work fine here.
- Temperature - appears to work fine here.
- Hold Mode - status never shows and does not change when I enable or disable hold mode
Comment