Go Back   HomeSeer Message Board > User Interface Plug-ins > User Interface Discussion

User Interface Discussion User Interface Plug-ins

Thread Tools Display Modes
Old June 26th, 2015, 11:46 PM
JorgeS JorgeS is offline
Join Date: Jun 2015
Location: 5049 N. Nordica Chicago Ill
Posts: 32
HS# log will not show Status of Water Sensor

HS3 (using Insteon plugin from Mark) - log will not show status of the device, it will only do so when on event is created (like, speak "water detected").

All other devices, like the motion sensor will show its status in the log.

However under the HOME tab, the device show its current status - Dry/Wet
Reply With Quote


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Everspring Water Sensor with FortrezZ Water Valve sparkman HomeSeer Z-Wave Plug-in 11 April 13th, 2015 08:41 PM
Water Sensor Issue madmax Lighting & Primary Technology Discussion 5 August 4th, 2014 06:55 PM
z-wave water sensor TeleFragger HomeSeer Z-Wave Plug-in 14 September 16th, 2011 03:38 AM
Water proof sensor peterpc Midon Design Temp05/08 8 February 26th, 2006 10:40 AM
Water sensor langenet HomeSeer General Discussion Area 2 May 2nd, 2004 02:11 PM

All times are GMT -4. The time now is 07:33 PM.

Copyright HomeSeer Technologies, LLC