I've run Zseer v1.1 and when I run TestAll, it reports that none of the nodes have any neighbours. There are no lines belween nodes (at all) and when I apply filter of "only show nodes > 1 neighbour" I don't see any nodes at at all, not even the controller!
The devices work as I can send instructions to dim / on / off etc. The nodes are close (within 3ft of one another in many cases) yet they don't register as neighbours?
Any ideas?
Thanks
The devices work as I can send instructions to dim / on / off etc. The nodes are close (within 3ft of one another in many cases) yet they don't register as neighbours?
Any ideas?
Thanks