Hello,
I had previously added an action button to perfom the following to my first installed Zwave switch:
Actions -
0 - Homeseer: Control a HomeSeer Device
Misc -
ActionType - HomeSeer: Control a HomeSeer Device
Device - Main Kitchen Main
Command - Toggle/On Off
Now when I try to do the same (all my Zwave nodes see connectivity and respond through the web interface) for my additional switches, the option to select a command from the drop down, displays nothing.
Even if I go back to my original (and only working button) there are no options to select "on/off/toggle, etc" its simply blank, however if I click cancel, I am still able to leave what was there (Currently Toggle On/Off) and it works.
Any insight is appreciated!
Regards,
Mike
I had previously added an action button to perfom the following to my first installed Zwave switch:
Actions -
0 - Homeseer: Control a HomeSeer Device
Misc -
ActionType - HomeSeer: Control a HomeSeer Device
Device - Main Kitchen Main
Command - Toggle/On Off
Now when I try to do the same (all my Zwave nodes see connectivity and respond through the web interface) for my additional switches, the option to select a command from the drop down, displays nothing.
Even if I go back to my original (and only working button) there are no options to select "on/off/toggle, etc" its simply blank, however if I click cancel, I am still able to leave what was there (Currently Toggle On/Off) and it works.
Any insight is appreciated!
Regards,
Mike
Comment