ADIO100 - ITACH IP2SL
Uhaoooo,
After some days of work I can see the solution of my problem. I hope that post can be useful to all those who use ADIO100 with IPSL2.
The problem was the bad position of DIP Switch inside Adio100 and the configuration of the COM port on the PC. I put the DIP switch in "ON" position (115200 baud rate) and the same thing in the configuration of the virtual port through the software "Virtual serial port emulator" (set 115200 baud rate) where I used the port 4999. Then in the configuration of the IPSL2, that it is possible to open after have found its IP using the software "iHelp" (Global cache), set the baud rate in the same way (set 115200 baud rate) .
Thahks at the your indications, Thahks Thahks
Massimo
Uhaoooo,
After some days of work I can see the solution of my problem. I hope that post can be useful to all those who use ADIO100 with IPSL2.
The problem was the bad position of DIP Switch inside Adio100 and the configuration of the COM port on the PC. I put the DIP switch in "ON" position (115200 baud rate) and the same thing in the configuration of the virtual port through the software "Virtual serial port emulator" (set 115200 baud rate) where I used the port 4999. Then in the configuration of the IPSL2, that it is possible to open after have found its IP using the software "iHelp" (Global cache), set the baud rate in the same way (set 115200 baud rate) .
Thahks at the your indications, Thahks Thahks
Massimo
Comment