Announcement

Collapse
No announcement yet.

Action of Z-Wave Actions could not be carried out because its configuration is not co

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Action of Z-Wave Actions could not be carried out because its configuration is not co

    Not sure if this should be here or in the general HS thread. I have a znet controller and all the sudden and am getting these messages.

    Event Kitchen Energy Check State, Action of Z-Wave Actions could not be carried out because its configuration is not complete.

    Any ideas?? i checked the event and it seems fine.

    #2
    The only time that I have seen this type of message is when a device that is referenced in the Event has been deleted and re-added with a new device number. When you view the Event, the action statement (then statement) should indicate that there is a missing device or device information.


    Bob

    Comment


      #3
      Interesting. The device has been removed and readded but the drop downs look good. I am going to reset them all just for good luck. Thanks for the tip!

      Comment

      Working...
      X