Current Date/Time: 1/31/2018 12:35:32 PM
HomeSeer Version: HS3 Standard Edition 3.0.0.368
Linux version: Linux hometrollerSEL 3.16.0-031600-generic #201408031935 SMP Sun Aug 3 23:56:17 UTC 2014 i686 i686 i686 GNU/Linux System Uptime: 1491 Days 9 Hours 16 Minutes 0 Seconds
IP Address: 192.168.1.38
Number of Devices: 46
Number of Events: 13
Available Threads: 199
Enabled Plug-Ins
1.0.0.131: Arduino Plugin
2.0.9.0: BLEmail
3.0.0.5: CM15A
1.0.0.9: HSInsteon
3.0.1.130: Z-Wave
Hi,
I am having trouble with my X10--CM15A. HS stops commands to the CM15A. However HS shows that the commands were sent. I tried Disabling then re-enabling the plug-in which does not work. I have to do a system restart before the X10 devices respond again. It seems I have to do this almost on a daily basis.
Any suggestion or advice would be greatly appreciated. Thank you.
HomeSeer Version: HS3 Standard Edition 3.0.0.368
Linux version: Linux hometrollerSEL 3.16.0-031600-generic #201408031935 SMP Sun Aug 3 23:56:17 UTC 2014 i686 i686 i686 GNU/Linux System Uptime: 1491 Days 9 Hours 16 Minutes 0 Seconds
IP Address: 192.168.1.38
Number of Devices: 46
Number of Events: 13
Available Threads: 199
Enabled Plug-Ins
1.0.0.131: Arduino Plugin
2.0.9.0: BLEmail
3.0.0.5: CM15A
1.0.0.9: HSInsteon
3.0.1.130: Z-Wave
Hi,
I am having trouble with my X10--CM15A. HS stops commands to the CM15A. However HS shows that the commands were sent. I tried Disabling then re-enabling the plug-in which does not work. I have to do a system restart before the X10 devices respond again. It seems I have to do this almost on a daily basis.
Any suggestion or advice would be greatly appreciated. Thank you.
Comment