I was attempting to update Polling Rates for device batteries and have managed to get the node into a state where i cannot add a new Polling Rate or delete the only existing one.
Set to change at 12pm to 0 Seconds.
The delete function is shown, but does nothing when clicked.
There is no option to add additional polling rates.
Is there a way to resolve this without removing and reading the z-wave nodes?
Thanks
Set to change at 12pm to 0 Seconds.
The delete function is shown, but does nothing when clicked.
There is no option to add additional polling rates.
Is there a way to resolve this without removing and reading the z-wave nodes?
Thanks
Comment